Can someone please tell me how to carve this pattern!! I have seven of these to make all with different names. First off I have the old quick release bit holder. I just can't buy the new parts right now. It takes me nearly 30 minutes to change the bit. Today i started this pattern trying to cut two at once one on each end of the board. It has always started on the right side. Now when I try to use just one on the board it starts on the left. Also when I tried to do one today it cut the pattern smaller than I wanted. I also got a Z Stall Error 303. That was a first for me. I know this makes no sense as to what I am doing. I am on a schedule to when I have to have these done. Also, when I try to load the program it takes nearly 5 minutes before it starts the homing process.
Thanks