Should recieve machine Saturday so still playing around with demo software and have a millon projects in mind. This one I need advise on best way to setup in program so any tidbits of knowlege will be much appreciated.
Briefly what I wish to do is start with a piece of ¾” stock and end up with an oval with an outer ring approximately 1” wide by full ¾ thick then step down and create a ledge 1/8” lower and ¼” wide. (This will be used to support a piece of glass.) Finally the center portion will be recessed an additional ¼” with carving/lettering standing proud.
Should I:
1. add outer line and select cutout
2. add middle line, select bit set at 1/8” depth and carve region
3. add last line with inverted pattern/text and carve region (can you carve region with carving bit?)
Hope this makes sense.
Thanks for any help….. Don