Hello,
While trying to cut, I received the following error:
Z Axis Stall Err. E06-0313. Pres STOP
This is very frustrating.
I have reviewed the forum and tried all of the different recommendations - no luck. While it is the same error as others, it seems to happen at a different point. I will explain...
Board is loaded, measured - everything is fine.
1/8 carving bit is installed - everything is fine.
Bit touches down a few times on the wood, bit plate (the one that swings out on the right) - everything is fine.
Bit touches down in the hole to the right of the board (next to the right hand guide) - everything is fine.
Bit touches down on the right hand guide and this is when I get the error every time.
I can press "Stop" and start over but I get the same result. Is there something else I can try? Anything I am missing?
Thanks!
David