I was messing around with a pattern,
trying to upload it and i get this warning.
could someone inform me what the warning is?
harley rack.mpc
I was messing around with a pattern,
trying to upload it and i get this warning.
could someone inform me what the warning is?
harley rack.mpc
Last edited by jaustin; 03-27-2011 at 12:38 PM.
Your cuts are too close to the edge of the board. It thinks it won't have enough material left for the rollers to press down on. If you're going to cut it on a sled, no problem. Otherwise, you need to decide if your willing to take the chance of breaking a bit or ruining the piece, and if not, use a slightly wider and longer board.
Looks like patern to close to edge . make smaller or board wider .
OLD SALT
Member CarveWright Start U team
thanks
Ill make board wider
Rules I follow that seem to work: Stay 1/2" from the top edge on cut throughs (except on a sled), If your actual board will have the requisite extra 7" ignore the left edge warning, If you have left 1/2" uncut along the top and near the bottom edge, ignore the cuts across the board warning.
Clint