Help With Pattern
This is a scan that I did, its a stile from a balcony that was salvaged from a remodel job
at the Yale Law School. Because its a deep carve ( .680) the tapered carving bit is making some of the areas at the top a little thin or distorted. I've numbered some of the areas that need fixing. The first one, number 1, (I don't know what that thing is, I'll just call it a peapod) you can see it looks great in the pattern editor, but not so good in the desinger. I did a test run and it came out just like you see it in the desinger. The peas are all distorted and the stem is about a 1/32 thick at the surface.I was wondering if there was someone who is good at editing patterns, that could help me docter this up by making the peas rounder and the stems thicker. Part of the problem is that the bottom of the carving isn't flat,its cove shaped so when I try to adjust the depth it just doesn't look the same, it losses a lot of what makes the original
look so good.
If you think you can fix it, Pm me and I'll send you the pattern.
Reply With Quote