Been wanting to make this hydrant for a long time. So tonight I sat down and created this one. It will be on my website later tonight on page 6 of the patterns.
First image is as seen in Silo.
Senior Member
hydrant
Been wanting to make this hydrant for a long time. So tonight I sat down and created this one. It will be on my website later tonight on page 6 of the patterns.
First image is as seen in Silo.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Junior Member
Looking good!
H. T.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
Friends Don't Let Friends Use bad patterns!
For high quality patterns please email me or check out my website at: http://carvenow.com . Thanks!
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
Senior Member
Senior Member
Thanks H.T. and John, been doing more reading than anything else.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Senior Member
Nice job Eddie.
Posting Permissions
Reply With Quote