Looks like you planed it.
Some things do work out.
OLD SALT
Member CarveWright Start U team
Adapt and Overcome! I had enough firewood
Very cool I love the antiquing of the wood! You when the power goes off, I have used the same board and started the project and it will air carve until it reaches the point it left off. Or in the designer you can put a region around the carved area just before where it left off and it will finish the project.
Ike
Thanks Ike
I did read on the forum about those two procedures. However I looked it up and read about it after I started the new board
Next time I will know but that might not let my imagination run WILD
Nice save Dvel56,
I admire both your design adaptation and you paintjob. Nicely crafted in the end so well done Sir.
Fair winds,
Capt Bruce
Kinney deSigns http://kinneydesigns.us
CarveWright START U Team Member.
30 year USN SEABEE, the original Weapons of Mass Construction.
Designer Ver 1.187 and 2.007, Ver.3.001 One 2009 B CW w ROCK and a 5th Year Anniversary C CW
Rotary Jig, 2D and 3D, Tracing Probe, DFX and STL Importers
.
Good save alright! You invented a brand new project. Good Job!
Michael T
Happy Carving!
╔═══ Links to Patterns & Resources for CompuCarve™ & CarveWright™ ═══╗