I tried to find any posted info before asking this question. I am sure it is probably happening because of operator error.
When I scan a smooth item (pistol grip) the scan ends up with a rough surface texture between that of rough concrete and asphalt. I am using a new machine (fall 2010) from CarveWright that came equipped with the scanning probe.
I have tried with each quality setting for the scan and all end up with the rough surface.
When I attached the item to be scanned to the scanning sled first time was with double stick tape. When that did not work out smooth I thought the tape might be allowing the item to move. Next scan I glued the item to the sled with CA glue so there was no way the item could move.
The image from the scan shows the rough surface and when carved it looks just like the image, rough. I would post the pattern image if someone is will willing to tell me how. I know this machine can do great stuff. Just need a little help getting the operator to function correctly.
Thank You in advance for your good help.