deleted to move to a different area of the forum
deleted to move to a different area of the forum
Last edited by lawrence; 01-30-2011 at 09:22 PM. Reason: moved to more appropriate area
You should be able to get pretty close with this linear gradient... just unzip, and then set the depth of your pattern to the deepest depth.. and the width to your 1/2. You may have to ratiate to get the orientation right. I'sd also set the heigth to 999.
Doug Fletcher
Using your MPC, you could assign Left or Right domes to each carve region, set the depth to .5, and the height to 999.
You could also apply a Taper Pattern, in lieu of your carve regions, set about the same way.
AskBud
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
I wanted to do something similar awhile back in the form of a wedge, I believe Bud even helped out with it and he has a tutorial on it.
" The Hurdier I Go, The Behinder I Get"