Use this thread to post patterns related to Religious and Inspirational
Use this thread to post patterns related to Religious and Inspirational
Not sure if this is where I should post my request. If not, no slamming!
I used to have a pair of angel wings pattern. I have a request for a carve and can not locate it. I searched this site without success. Can anyone help locate one or does anyone have one?
CWPatterns.com - Search, browse, download, all FREE!
Spawned on 1/18/2011 - Over 700 patterns and climbing.
This website can be used as a flotation device."
Jonny, these are great, but need the wings a bit more flowing, feathers showing, and joined in the middle. I guess I should have stated this in prior message.
was it closer to this?? This was posted by eelamb orginally.
Doug Fletcher
Azbear
if this is the patern you are looking for PM me with your email address and I will send it to you.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
I have been working on a pattern, and thought I was done with it, but noticed one of the angled sides on the 5 point is missing on the bottom. Will have to figure this out. But here are a couple of images of the Luther Rose I have been working on. Sometime in the next day or so I will fit it and have the pattern ready.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
When you say attached, just the points, or more of a over lap. To answer your question, yes I can attach them.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie