Another Masterpiece.....
Good Job,
AL
Another Masterpiece.....
Good Job,
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Thanks for posting the video, LG. That was FUN to watch!
Michael T
Happy Carving!
╔═══ Links to Patterns & Resources for CompuCarve™ & CarveWright™ ═══╗
Are you using the CC to carve out the areas for the electronics, and the neck, in the body blank?
I want to dabble in this a bit, but everyone tells me I need to start with a 14" wide body blank.
Are you carving those cavities in each half, and then gluing them together?
I haven't yet been able to get back to using my CW, but I wanted to ask - are you using 'conforming vectors' to carve out the area? (Am I getting the terminology right?) If so (and I might have asked, and received an answer on this already - I just can't find it), do you have it carve a relief with the pattern bit until it gets thick enough to use something like a 1/2" bit, and then have it do the remainder of the cutting? I would assume this is possible, if you configure the lines correctly?
"Build a man a fire, and he'll be warm for a day. Set a man on fire, and he'll be warm for the rest of his life."
my jaw drops every time I open one of your posts... stunningly technical, well exectued, and beautiful work.
Lawrence
As usual, unbelievable job!!. Curious as to what wood you used?
Love to Make the sawdust, But I sure Hate to clean it up.
U can't find Success unless you have the patience to hang around long enough to find it!!!!
Website isn't carving related but a good place to buy a auto:
www.hcautos.com
Beautiful workmanship again Brandon!.... Hey, I drove right past your exit in California last week. If i had time i was going to look you up!
Hope you are doing well, and the Rock Chucks are still serving you well!
Ron
To order the "Made in USA" Rock Chuck, and other custom tools and accessories I make for your CarveWright, see my website by clicking here -> http://www.cw-parts.com
See a quick video of the new Rock Chuck in action here!
Read up on QC Removal for stubborn chucks here
See the Rock install video here
You can also visit here for discussion content.
Email me by clicking here
Very nice job Brandon, you just make me want to wrap my fingers around that neck and give it a try........and I'm sure it sounds as good as it looks. Thanks
CarverJerry
CarverJerry
ver. 1.188 Win 7- 64b with 6 GB ram @ 2.8Ghz and dual 1Tb hard drives. Rock Chuck & Ringneck vacuum system hooked up to a Harbor Freight large vacuum. Center line text, conforming vectors.
You do some great work. Did you get the price compared to that of the Les Paul?
In Him, Mike
msphilpott@tnet.biz
Quilted Maple pick guard,, Nice touch !!!
Mans Quest for knowledge,,, means he'll always find a way !!