1.175 unkown error 12288 on upload

[bergerud]

I cannot upload any patterns to the card with the new release 1.175 build 8804 . After flashing the new firmware I get "unknown error 12288 when compiling project". I am using Windows XP pro. Anybody else have this problem?

[lhanner]

No I do not have the same error you are having.
I am having problems when I try to create a dome shape.
I create a region and select surface.
I select dome, vertical, OK and it will not let me out of the surface selection.
I have to go to task manager and close designer down.
I am using a acer laptop running VISTA pro.

[RMarkey]

That error should never happen. Please contact our software support team so you can send your project file to them.

[bergerud]

Correction: I cannot upload double sided carvings to the card. I have tried many double sided projects, no matter how simple my bitmaps, I get the same error. Has anybody tried to upload a double sided carve? I may be wrong, but I think 1.175 has a problem. For example try the attached project. I cannot upload it.

[liquidguitars]

Bergerud,

I downloaded your MPC is working on my machine..

[bergerud]

Thanks. Now the error has stopped! (Just after I posted of course.) I cannot explain it.

[bergerud]

Update on upload error 12288: It still occurs on my home machine but not always. I have now tried my office machine and I get the same error. (with any two sided carve.) The problem has to be version 1.175. (or my memory card)? I am stll waiting to see if anyone out there has experienced the same error.

[AskBud]

I went to one of my 2-sided carves and had the same error while using 1.175. I'm using PX on all PCs. I also recompiled the MPC after the initial failure on 1.175, just to be sure that was not the problem. The original MPC was made prior to 1.175 (1.153 or before).
Report sent to Support 10/7/2010.
AskBud
Milk Cow-3.mpc

[lynnfrwd]

The software "Guru's" are looking into it. All of the information that you can provide is most helpful in identifying the problems.

Thanks as always!

[bikeaccdnt]

I'm also having the same issue. Two sided carve version 1.175 with the Maple leaf project. Windows XP, tried two different cards. Both cards can upload single sided but not double sided. Its not the card or card reader. Also tried doing same thing on Windows 7 computer. Same thing. There is one message that does come up.
Attachment 39192
The project uses features that can not be scaled. Scaling by the Carvewright machine will be disabled

I can upload a double sided carve that can be scaled. May be the Disabled scaling ?