CarveWright Designer wishlist

[SAA3840]

LOL Made my posting and then saw that the previous two addressed exactly what I wrote about. So I deleted it.

[roughcut]

I wish they would add an option so you could momentairly run the different axis to test there operation. Like when you change belts or z-truck.

[TIMCOSBY]

I think that if you display the Carve-List, and hold down CTRL and CLICK on EACH item you can do it now.
The design will have each item active and there are YELLOW Arrows in the corners that will allow you to size the entire design.
Do not use any of the RED Nodes!. I must say that I'm not sure if it also sizes the Cut-Paths as I did not check that aspect.

PS: OOPS
Sizing changed OK, but when I then changed the Board size the individual items did not stay in the same location as on the original.

that if you attached all items to the left edge then they wouldn't go all crazy and have to be moved but i haven't tried it.

[AskBud]

I wish they would add an option so you could momentairly run the different axis to test there operation. Like when you change belts or z-truck.

Would a "Measure Board" do the job?
AskBud

[RMarkey]

Yes, if you're not cutting, you can put multiple board pieces in the machine and measure width to get the Y truck moving the full range...

[leroy]

Need adjustable Cutpath depth so Cutpath can be used when using a sled on less than .5 stock. Or ability to insert tabs to lines

[mtylerfl]

Need adjustable Cutpath depth so Cutpath can be used when using a sled on less than .5 stock. Or ability to insert tabs to lines

Hello Leroy,

You already have that feature (cutting on a sled with stock less than .5" thick) since last year starting with Designer version 1.131 of the software! You can also specify the number of tabs and their thicknesses. More than enough features to enable you to cut out thin stock without any problems.

Read the Tips & Tricks - ISSUE 12 September 2008
"Designer 1.131 New Feature Highlights "

[sweliver]

just like the current drill function but rect/square.

sw

[cnsranch]

just like the current drill function but rect/square.

sw

Is there a square bit in the set?

[roman]

Hi guys i just want to download again the trial software the carvewright offers and is there any way to download again ? reason asking for second chance is i had virus and i had to clean everithink .