Continue carving after X axis stall

[shotgun 6]

I just had a X axis stall caused by a chip of wood coming loose and jamming against the rollers. I was approximately 90% through a 3 1/2 hour carve. Is there any way to make the machine pick up at the point of the stall or do I have to start over all over again from scratch?

[Digitalwoodshop]

Unless the machine gives you the option Abort or Resume then your stuck... Do a search on the topic and many have had success putting a rectangle over the already cut stuff and making it a zero carve region. The machine will still do the 3 hours but not try to cut it again until the uncut area.... sorry....

AL

[shotgun 6]

Thanks, Al. I think I'm stuck because it only gave me an "X axis stall." Think I'll try and run it again and see what happens.