Two sided carving clarification.

[jcaravella]

I just a bit confused before I test a two sided carving. Will the machine stop after carving one side and prompt the board to be flipped to carve the other side if the two sided is on one board in the software? rather than having two separate files in the designer software?

THanks
Joe

[AskBud]

I just a bit confused before I test a two sided carving. Will the machine stop after carving one side and prompt the board to be flipped to carve the other side if the two sided is on one board in the software? rather than having two separate files in the designer software?

THanks
Joe

The short answer is YES.
You design both the front and back/rear. The back will be carved first, and then at the prompt you roll the board as it you were turning over in bed.
I have 3 old lessons in my "Download" link, below, that show the concept. Since they were may last year, there are more options provided by the LHR updates.
AskBud