Now there are a couple more things I need to figure out. I will be reading through the software manual and tips to see if I can find a solution. If anyone would like to give advice or any directions please make a post. I really appreciate the help.
#1 How to make countersunk holes for the screws. Looking at the takeoff grips I have it looks like the largest hole matches the carved pattern. Measuring from the outer surface about 1/16" down the hole needs to be smaller by just over 1/16". I am assuming this is to hold the head of the mounting screws.
#2 The backsides of the grips will need to be grooved for the safety and ? The grip to the left looks to be about 1/8" deep and the one on right about 1/16". I need to figure out how to carve these out of the backside and how to do a cut path to cut each grip out of the board. In summary; how to set up the project to do the carving on the backs and then be able to flip the board to carve the fronts and then cut out the grips utilizing tabs. I hope I am making sense here.
Once again, any help, advice or encouragement is greatly appreciated. I'm not dumb, .... but maybe a slow learner. I just started experimenting with the machine a couple days ago. You guys are helping to speed up the learning process immensely. Thank You.