I just replaced the Z axis motor with a warranty replacement and upgraded the sandpaper belts tot he rubber belts on my refurb machine I bought in June.
When I go to start up the calibration sequence I immediately get a Z-axis Stall Err E06-0313 error with jsut a fraction of an inch movement vertically in the head.
I made sure the cables to the board on the cutting heard were in good shape and not crimped in any way. I made sure the head had free movement and that the bearing clips were not binding up and that the tension adjustment screws on the head was not tight all the way.
I have the latest version of the software (1.77) and could use a few suggestions on what to check going forward since I cannot find a problem of this description in the Forum.
Thanks,
Baron Richard
Wandering Wood Products