Version 1.177
Now accepts 3/16" Cutting Bit!
December 2010 -- Differences between versions 1.177 and 1.176
* Added support for new 3/16" cutting bit
* Fixed broken blur tool in the Pattern Editor
How about that!
AskBud
Version 1.177
Now accepts 3/16" Cutting Bit!
December 2010 -- Differences between versions 1.177 and 1.176
* Added support for new 3/16" cutting bit
* Fixed broken blur tool in the Pattern Editor
How about that!
AskBud
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
Anyone else having trouble updating? I've gone through it 4 times and nothing has changed in Designer.
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
I suggest you use the 3/16" tabs whenever using the 3/16" cutting bit.
I also suggest a downdraft system when doing cutouts as sawdust will build up under the board, instead of carving where it builds up on top of it.
was the 3/16 cutting bit invented so we could do full 3/4" cuts?