Bits and sharpening
I am new here to the forum and it is my first post. First thing first...coodoes to the Carvewright team. The router is fantastic and I am having a ball doing things that have taken me forever (or at least seemed like it) .
My question is two fold....
1. From reading a few of the other post on engraving and carving small letters, it doesn't seem possible yet. However...is there any bit out there that would do the job? Like a Dremel engraving bit and i am sorry if this has already been answered.
2. For the two bits that were included with the CW...when time comes, is there a recommended fashion on sharpening the bits? Can they be sharpend using, sya, the Drill Doctor that is available on the market?
Thanks
The Toymaker
One can not move forward until they leave the past behind