Originally Posted by
DaveN
Hi everyone,
I did a scan of a stile 2.75" wide 24" long, and about 3/4's of the way through the scan, it looks like the Y axis shifted about a 1/16". Its as if the stile was cut in half, then butted back together
end to end offset about a 1/16". The part didn't move, I used double sided tape to hold it down and because its over an inch thick, I surrounded all 4 sides with 1/2'' material and that too
is held down with tape. My 1st question is has anyone seen this before and if so, how can I fix it. My 2nd is can the pattern be fixed in the pattern editor? I tried but it doesn't look like I can, Im new
to CW so maybe Im missing something.