Thanks everyone... I'm now up and running again. I checked the length of the cutting bit with my carving bit and there was a small difference in length (carving bit was longer). I then put it on the grinder and made them both the same length and all is working fine now. I am now using all of my bits without the collars and checked them all to make sure that they're all the same length. It's wierd that just that one carving bit (out of 5) was about 1/16 longer than all of my 1/4 bits. It does make sense that something has been done that the machine is now more "picky" with the bits. I'm just glad that I'm up and working again. I may try later to find me some type of shrink tube that I can cut just a small piece to make a thin collar for the bits. That way I make sure that they are always set at the exact same depth in to the RC. Anyway, thanks again for everyone's help and suggestions. Once again the Sawdust Dream Team comes through!
JerryB:.
CarveWright START U Team Member
Using 1.187, Conform, PE/Probe, Centerline.
"Let's start sharing PTNs instead of MPCs so ALL SW versions can view & share"