Need help with a carving

[Fardoche]

Hello,

I want to do this carving that have and angle but I don't know how to make angles.

have include pictures and measurements.

If anyone of you can help me it would be very appreciated.

The measurements (top view) are 2 1/2 x 1 1/2 in a 3/4" material

Thanks in advance.

[AskBud]

Hello,

I want to do this carving that have and angle but I don't know how to make angles.

have include pictures and measurements.

If anyone of you can help me it would be very appreciated.

The measurements (top view) are 2 1/2 x 1 1/2 in a 3/4" material

Thanks in advance.

See if this Tapered pocket (MPC) works.
AskBud
Tapered Pocket.mpc

[Fardoche]

Thanks a lot Bud,

this is what I'm looking for.

The lower side of the carving if rough and I don't know how to fix it.

Any cue ?

Hello,

I want to do this carving that have and angle but I don't know how to make angles.

have include pictures and measurements.

If anyone of you can help me it would be very appreciated.

The measurements (top view) are 2 1/2 x 1 1/2 in a 3/4" material

Thanks in advance.

[AskBud]

If this is wood:
It could just be that your QC adapter is not seated properly, as there would be a lot of stress on that deep carve. I would also use the "Optimal" option.
If this is Corian:
You will need to do the deep part as 3 different projects with a MAX of 1/4 inch on each carve. Read the cautions/specs from LHR.
AskBud

[mtylerfl]

If this is wood:
It could just be that your QC adapter is not seated properly, as there would be a lot of stress on that deep carve. I would also use the "Optimal" option...
AskBud

Unfortunately, it appears the roughness is actually integral to the pattern itself (lines/ridges).

[AskBud]

Michael,
I see what you mean.
I'll try to develop new tapers, rather than taking one from the book/web.
AskBud

[AskBud]

Here are two new tapers.
Taper-Vertical Revised 8-10-2010.ptn
Taper-Horizontal Revised 8-10-2010.ptn
AskBud