Originally Posted by
myshop1044
I want to do some lettering on 1/4" corian. I am going to attach it to a 1/4" base sled, just tape them together for support. This will give me about a 1/2" thickness overall. My question is, will cw adjust the depth of the lettering using a 60 deg "v" bit to the 1/4" corian or the 1/2" total thickness of the sled? I don't want a deep lettering, just a lite lettering.
any input would be great.
Myshop
Center line carving has nothing to do with the width of the board. It carves on the width of the lines of the type stile you chose. The “60 degree V" bit will carve deeper than the 90 degree bit. If you use bold type it may go deeper than 1/4th inch.
Using Designer Version 1.187
Donations are always welcomed, thanks – send a check to my PO Box 652
BJB
PO Box 652
Yellville,AR 72687-0652
PM me for my e-mail address.