Hey all,
Here is something I found I have a need for. After loosing a tiny spring, the type that takes a thousand of them to make an ounce, I searched my shop floor for half an hour before I found it. As a result of that ordeal, I drew this surface in CW Designer. It will catch all those tiny parts before they get accidentally brushed off the bench. It measures 16 X 14 and will carve using only the carve bit. My plans are to carve this and glue another board the same size, just not carved, to the bottom. That way I will have a nice heavy, thick work surface to disassemble things on.
Enjoy,
Bill....