is the bottom of your sled at least 3/4" material? if its 1/4" it may have some up and down movement too.
is the bottom of your sled at least 3/4" material? if its 1/4" it may have some up and down movement too.
My first and only scan and my reaction to the noise was much the same as yours. Like an old dot matrix printer while it tapped its way across a formerly gilded wood surface. As shown below it added a surface texture that was not there on the original. Had to clean it up using the filters before going to the final pattern from the scan.
Attachment 38554
Now that I know from that experience what to expect I won't be so surprised or worried next time. Just count on having to do a little clean-up. Save copies as you work through those steps so you can go back if necessary.
Fair winds,
Capt Bruce
Kinney deSigns http://kinneydesigns.us
CarveWright START U Team Member.
30 year USN SEABEE, the original Weapons of Mass Construction.
Designer Ver 1.187 and 2.007, Ver.3.001 One 2009 B CW w ROCK and a 5th Year Anniversary C CW
Rotary Jig, 2D and 3D, Tracing Probe, DFX and STL Importers
.