Results 1 to 2 of 2

Thread: Configuring big projects

  1. #1

    Default Configuring big projects

    Hello everyone, I have a question that hopefully I can get an answer for. Does anyone know how to re-scale a pattern to fit a bigger projects that can fit. I'm trying to make a poker table with the poker dogs engraved on the table top with a glass put over it. I was wondering if anyone has done a big project like this, and how did you scale the pattern to fit exactly on each section of wood.

    Jason Sawyer
    Last edited by 04302296; 06-21-2010 at 01:58 PM.

  2. #2
    Join Date
    Feb 2008
    Indian Lake, Ohio - Rts 33 & 235


    See if this Tip & Trick will give you the info you need.
    AskBud Downloads =>> CLICK HERE
    Lesson added
    7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"

    CW Vacuum Head Project =>> CLICK HERE
    AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons

    More than 1250 AskBud patterns
    vvv-CLICK BELOW-vvv

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts