Originally Posted by
undrtkr
I just installed the new CarveTight spindle & z truck. I did a short (15 min.) centerline text carving with a 90 degree V in soft pine. The whole z truck was almost too hot to touch. Does anyone know if this is "normal" for a new assembly?
Any advice will be appreciated.
Tom
I would say NO!!!
but did you also lube your flex shaft?
Using Designer Version 1.187
Donations are always welcomed, thanks – send a check to my PO Box 652
BJB
PO Box 652
Yellville,AR 72687-0652
PM me for my e-mail address.