Will not scan

[Digitalwoodshop]

Do you have the jumper cable for the probe to plug it into the cover?

DO I understand you have the new Z setup and don't plug into the Z anymore.

AL

[andes]

Yes I have the new Z setup and the jumper cable.

Do you have the jumper cable for the probe to plug it into the cover?

DO I understand you have the new Z setup and don't plug into the Z anymore.

AL

[andes]

Bud I did review the video and read the probe manual again. I followed the steps.

Let's review the master video on the Scanning Probe.
AskBud
http://www.carvebuddy.com/scanningvi..._it_works.html

[andes]

anymore ideas/suggestions on what may be causing this issue?

[PCW]

Make sure the plug on the Y termination plug is oriented correctly. White goes towards the center of the machine. Also make sure it is plugged in good.

[RMarkey]

When the screen shows "jog to ending corner" what are the final dimensions displayed?

[andes]

Dan,

Rechecked the Y term cable -- its oriented and seated correctly


Metallus,

the final dimensions are 0.00" long x 6.79"

[PCW]

Dan,

Rechecked the Y term cable -- its oriented and seated correctly

Andrea,

Where you able to locate the probe sensor in the options menu on the machine and if you did where you able to check to probe state?

Checking The Machine’s Onboard Sensors
The status of each of the machine’s onboard sensors can be accessed
from the LCD screen and keypad for the purpose of troubleshooting. To
access the Sensor Check menu simply select the “0” (Options) key at the

CarveWright Main Menu

or use the up/down arrows to locate the

Configurations Menu

and then press ENTER. Next, select the “7”

(Measure) key or use the up/down arrows to locate the Sensor Check
menu and then press

ENTER. Navigate through the different sensors and
associated status values using the up/down arrows.

Probe State
State – Open/Closed
With no probe installed, the Probe State will be displayed as Open. The
operation of the probe can be checked while installed in the quick changer
and plugged into the connector. Once installed the LCD will read Closed.
To check the operation of the probe simply reach in and deflect the probe
tip to the side. If the probe is operating correctly the displayed state will

change from Closed to Open.

[TIMCOSBY]

if so then something is not getting the length.

[andes]

Nope. But I just did and it’s scanning. Let’s see how it comes out. Boy do I feel dumb. Wow too cool. Thanks

if so then something is not getting the length.