http://william.bowen.com/:)
("There is a principle which is a bar against all information, which is proof against all arguments and which cannot fail to keep a man in everlasting ignorance-that principle is contempt prior to investigation."
- Herbert Spencer )
http://william.bowen.com/:)
("There is a principle which is a bar against all information, which is proof against all arguments and which cannot fail to keep a man in everlasting ignorance-that principle is contempt prior to investigation."
- Herbert Spencer )
1.163 flipped the small radius arcs in this project, making a mess. OK in 1.162. Fixed in 1.164?
Carving Pattern: All stop no carve? Help!!
Lee
Pop's Fix It Shop, We won't make it any worse.. Using "A" machines 1.187 1.188 ,2.007, 3.103
2 Machines no waiting.
Fetal error ( 4) Please reboot @ 52 machine Help
Lee
Pop's Fix It Shop, We won't make it any worse.. Using "A" machines 1.187 1.188 ,2.007, 3.103
2 Machines no waiting.
Possibly caused by an electrical spike from a vacuum - or power fluctuation due to the power company, or the machine is sharing the circuit with another appliance which caused a 'brown out" when the other appliance was turned on. I had a guy awhile back tell me he was getting the same error intermittently- turned out he had a freezer in the garage on the same circuit as his CarveWright. When the freezer cycled on, it caused a momentary brown out which triggered the error.
You may be able to salvage the project by re-carving the same board -you can use the trick of placing a zero carve region over the already carved area of your mpc, then load that new version to your memory card. Best to leave the board in the machine - better chance of the carve matching the already-carved area (overlap the area slightly).
EDIT: another possibility if nothing else checks out as the cause - the power supply of the machine could be faulty
Last edited by mtylerfl; 05-01-2010 at 06:02 PM.
Michael T
Happy Carving!
╔═══ Links to Patterns & Resources for CompuCarve™ & CarveWright™ ═══╗
roughcut or liquidguitars, maybe you could post this question. I dont' appear worthy of getting a reply.