OK... here's whay I was drilling all those holes. I'm so used to CorelDRAW that I had a lot of trouble. I ended up using the copy-offset for every hole on there. I made the layout in corel, then I figured out the distance between holes and entered that in the offset boxes. I copied groups of holes where applicible.
I designed this from scratch in Corel, so it's all mine (no copywright stuff) so feel free to use it, I only ask that you report back and tell me how you made it, and what improvements you made.
I tried to make a radius, but I'm not sure I used the route function correctly. Can someone take a look? I'm also not sure how I'm supposed to make the cut line so it lines up with the outer radius of the roundover.
The dog is just an example of where to put a graphic.
How would you have gone about making the holes?
Shaddy