How do I set the bit depth to make more than one pass in order to not cut so deep that it stales out the Y axes.
Thanks
Wilbur
How do I set the bit depth to make more than one pass in order to not cut so deep that it stales out the Y axes.
Thanks
Wilbur
When you assign a bit to a path the same window has a block at the bottom to set the depth of each cut.
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Thanks a lot. I have never done this. I seen it but never though that it was for that.
Wilbur