Originally Posted by
dbfletcher
Please make sure you fully understand how the machine will react with out bit stops as well. If you not using them, there is really no point in going thru all the bit changes at the start of the project. I typically just leave the carving bit in since that is the last one to be measured and the first one used. When prompted to change bits during the carve, after inserting the correct bit, you can safely chose "continue" when the machine prompts about the bit depth not matching. Hope that helps,
Also, although this method works fine currently, there is no gaurentee that this will remain the case in future firmware revisions.
Thanks,
Doug Fletcher