Results 1 to 3 of 3

Thread: belt not moving wood after mid point

  1. #1

    Default belt not moving wood after mid point

    HELP.. when the machine is measuring my wood it does not look like it is moving at a consistent pace and when the end of the wood gets to the middle of the machine the wood stops and the machine thinks it is still mesuring.????? if I don't abort it, it will measure all day and not move the wood. I noticed that my back belt is over to the right about a 1/4 inch vs the front one. That might be the problem. Can anyone tell me if you look at your back belt is that OK? The back belt on the right side looks like it has climbed over some round barrier that is probally to stop it from moving to the right.

    thanks

    Mike
    Attached Thumbnails Attached Thumbnails help_cw_909.jpg   help_cw_625.jpg  
    Mike

  2. #2

    Default

    Mike,
    I'm sure the CW people will chime in. It looks like your belt is starting to roll up under itself on the one side. Thats what it looks like in the pic I just had this problem, that rool up seems to liftt the wood up off the sensors. Contact the CW people and they will send replacement panels.

  3. #3

    Default

    Mike,
    I'm sure the CW people will chime in. It looks like your belt is starting to roll up under itself on the one side. Thats what it looks like in the pic I just had this problem, that rool up seems to liftt the wood up off the sensors. Contact the CW people and they will send replacement panels.

Similar Threads

  1. We're Moving
    By cmorlier in forum Announcements
    Replies: 7
    Last Post: 03-14-2007, 01:46 PM
  2. I need some dancers point shoes/dance related carvable art.
    By princess sawdust in forum Projects Gallery
    Replies: 9
    Last Post: 02-16-2007, 10:22 AM
  3. Sandpaper belt slid to the right and wood will not move
    By Mike N in forum CarveWright Machine
    Replies: 8
    Last Post: 01-21-2007, 01:16 AM
  4. Designs moving around
    By Aaron B in forum CarveWright Software
    Replies: 3
    Last Post: 11-22-2006, 06:34 AM
  5. Moving Text
    By Aaron B in forum CarveWright Software
    Replies: 2
    Last Post: 07-12-2006, 06:01 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •