Hi,
A new problem. The small arm on the right hand side of the machine for the purpose of setting the cutting bit is not swinging out. When traversing to the right side I am now hearing a slight clunk. The arm swings out a mere 1/4 and the bit just bypasses it as it heads to the machine base. If I move it with my finger it moves easily and is not jammed.
It is in the cellar and we have had single digit temps and I am wondering if that may be contributing to whatever movement causes it to swing out.
Yesterday I lubed the flex cable with a moly-base but I don't see any correaltion between that and the arm.
Anyone run into this before?