Cover

[bobtom]

Hey guys:

I need help.......
please close cover message appering

Cover is closed. I can hear the switch clicking
as I open and close the cover.

I actuated the switch by hand.

Message still appearing. Turned machine on and off.
Message goes thru the menu to select program,
Then repeats close cover message.

What do I do next?????
Thanks in advance
Bobtom

[mtylerfl]

Blow dust out - check mounting screws - check all connections - order a new switch if those don't fix it. Could also be dirty contacts inside the switch.

[Eagle Hollow]

Pick up the micro switches at you local electronics store. Between $5 and $8 and you don't have to pay $12 for shipping and handling.

Good Luck

Jerry C.

[Digitalwoodshop]

The plug in the back with the wires needs to be installed with the white wire toward the center....

If that does not do it than use air and blow inside the switch....

AL

[SteveEJ]

Make sure you are looking at two switches! The one near the keypad is the cover switch and the one on the opposite side is the cut motor safety switch!

[bobtom]

Thanks for all the replys.
You have given me food for thought.
And action in the morning.

Thanks again to all.
Bobtom

[AskBud]

Thanks for all the replys.
You have given me food for thought.
And action in the morning.

Thanks again to all.
Bobtom

Begin by doing the "Sensor" check. It could be that the switch is out of adjustment (just enough that the cover leaves it change status as the unit starts the run the board/bit). Vibration will play games with the cover switch.
AskBud

[bobtom]

Thanks to all for the info.

I found the problem. It was a bad limit switch.
I will see if I can find one localy Monday morning.


Thanks for all the replys
It was needed information.

Bobtom

[Digitalwoodshop]

Another HAPPY Carver....

AL