Z Axis Stall 308

[philpop]

I to get quite a fiew "Z" axis stalls and there is no saw dust under that cover.
Do you have any sujestions to help me.

[Zap]

take off the back plastic cover of z motor, check for sawdust, mine was full of sawdust, giving me a z axis stall

I just had time to go check this today and although I didn't see any sawdust there I blew it out, along with the rest of the Z Truck, really well and I'll be if it didn't start carving!

Thanks all!

Zap

[Digitalwoodshop]

Might have been a loose plug on either end of the Z Motor.... Under the dust cap or at the motor circuit board....

Good Job,

AL