Results 1 to 7 of 7

Thread: One of my projects

  1. #1
    Join Date
    Feb 2006
    Location
    Kansas City
    Posts
    254

    Default One of my projects

    Here is a picture of a poster mini poster case I that I sell to customers, the Carvewright machine really makes it easier to create in less time.[/img]
    Most folks are afraid of heights, me I fear width.

  2. #2
    Join Date
    Feb 2006
    Location
    Holden,Missouri, U.S.A.
    Posts
    1,832

    Default

    Very nice Robert, Do you also do the beading on the carvewright, and what else? What about the
    edge routing? Daniel near K.C.
    1.187 Custom Woodworking for more than 40-years

  3. #3
    Join Date
    Feb 2006
    Location
    Kansas City
    Posts
    254

    Default

    Hello Dan, I only used the carvewright in the center section, Its quicker for me to use my router table on the side and bottom pieces, its all about efficiency for me. I can turn out more pieces this way.
    Most folks are afraid of heights, me I fear width.

  4. #4

    Default

    real nice!

    What's the material you used for the center piece and what size is it? It looks like it has carved quite smoothly on the machine.
    Dave

  5. #5
    Join Date
    Feb 2006
    Location
    Kansas City
    Posts
    254

    Default

    Thanks Dave, I used 1/2" MDF in the center, it does carve quite smoothly, but does create alot of dust. I stopped the machine several times during the process to suck out the dust.
    Most folks are afraid of heights, me I fear width.

  6. #6
    ETAP6 Guest

    Default

    Hey that looks awsome!! How did you get the pocket w/ raised letters? That was not done in the Raster was it? [/img]

  7. #7
    Join Date
    Feb 2006
    Location
    Kansas City
    Posts
    254

    Default

    Thanks! Yeah that is done in raster, I just selected the area around it first and set it to route the area and then did my lettering. Here is an updated picture of what it looks like finished, this customer wanted it to look very old and worn.

    Most folks are afraid of heights, me I fear width.

Similar Threads

  1. my first couple of projects
    By bamaman315 in forum Projects Gallery
    Replies: 42
    Last Post: 08-29-2011, 10:52 AM
  2. finished projects!
    By newcarver in forum Projects Gallery
    Replies: 8
    Last Post: 02-10-2007, 05:45 PM
  3. A FEW OF MY PROJECTS
    By hartwoods in forum Projects Gallery
    Replies: 9
    Last Post: 01-21-2007, 07:47 PM
  4. projects needed
    By bivster in forum Techniques
    Replies: 1
    Last Post: 01-08-2007, 06:14 AM
  5. Projects
    By applik in forum CarveWright Software
    Replies: 1
    Last Post: 03-20-2006, 04:22 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •