Pine cone carvings

[TRanger]

Just figured out how to post here.

I need 20 base relief carved southern pine cones on a square, for using on doors as decorations. Cone needs to be about 4" long.

Anyone have any ideas? If interested post here or email, need to see representative sample of cone.

[Aaron B]

Is this something similar to what you a looking for? I not sure how good it would come out, maybe someone else has some better pictures that would import and look better. The first & second pictures are the same just one is inverted.

[Matty]

Here is a corner ptn if any one wants it


Matty

[BobHill]

Thanks, Matty,

Always looking for designs to put into my library.

Bob Hill
Tampa Florida

[Juno2]

How about these?

[TRanger]

Got more out of my partner in crime with these doors. What he wants is a three dimensional pine cone, about 4 inches long, that can be used as a raised carving on door panels. He is interested in if then can be cut free, or made three dimensional without the block. And of course, production cost.

[SAA3840]

I don't know where I got these, but how's this?