Y axis stall
Sounds to me like the continuation of the problems in 1.132-4 where the firmware attempts to determine whether or not there is a problem by noting the added energy necessary to do something. Good idea if it had an accurate knowledge of all the parameters like density of the material, difference in Z height from the base-line etc. etc. The problem is/was that those parameters don't seem to be included or sought.
Just my thoughts, maybe that is not the problem. Although, I did not see those corrections in their noted bug-fix for 1.150.
Ken,
V-1, 2, & 3
When the People fear their Government, there is Tyranny.
When the Government fears the People, there is Liberty.
- Thomas Jefferson
You must be the change you wish to see in the world.
- Mohandas Gandhi