I have a project with just one centerline carving of a dingbat but when I try to upload the project to the card I get the following error, "It has been determined that the project being uploaded does no carving. Cannot continue, sorry."
There is definitely something there to be carved (see pic). I know the font, or at least part of it, works cause I can do the same thing with another letter. This is a capital A and the capital B glyph works fine if I substitute it into the same project.
Any ideas why this glyph would show properly in the designer but then not be seen when the project is uploading?
Edit: ok, just found something else: the design is set to 8.5 inches, I accidentally resized it down and it would upload. I checked a bunch of different sizes and it will only carve at 4in or smaller. Anything over that and i get the error. But I need it at 8.5in