I am encountering some rough printing when I am carving some letters.
In raster mode it looks like the bit plunges and then moves along the carve line and plunges again. The result is a series of half circles on the edge of the letter.
Dan
[/img]
I am encountering some rough printing when I am carving some letters.
In raster mode it looks like the bit plunges and then moves along the carve line and plunges again. The result is a series of half circles on the edge of the letter.
Dan
[/img]
Please give us a call at 713-473-6572. We'd need more information to diagnose this, and a phone call would probably be more productive.
Britt Yenne
CarveWright