Originally Posted by
mfdchief
I just posted the PDF in the trouble shooting section as well.
I have followed everything line by line and when I get to the Calibrating the edge sensor, I get an error 400 edge detection error. I have replaced the board sensor and get a white paper reading of 155.
Does anyone know if these are the proper cuts for the edge detection calibration? I get the failure shortly after the full depth cut. The cuts seem pretty sloppy to me but I have never had to do this before. My board was planed VERY flat and edge jointed for squareness. It was a piece of pine .750 thick, 5 inches wide, and 38 inches long
Thanks
Mark