Results 1 to 6 of 6

Thread: Rubber Belt Calibration

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 06-06-2009 #1
    mfdchief
    mfdchief is offline Junior Member
    Join Date
    Jan 2007
    Location
    Maquoketa, Iowa
    Posts
    60

    Default Rubber Belt Calibration

    I just posted the PDF in the trouble shooting section as well.

    I have followed everything line by line and when I get to the Calibrating the edge sensor, I get an error 400 edge detection error. I have replaced the board sensor and get a white paper reading of 155.

    Does anyone know if these are the proper cuts for the edge detection calibration? I get the failure shortly after the full depth cut. The cuts seem pretty sloppy to me but I have never had to do this before. My board was planed VERY flat and edge jointed for squareness. It was a piece of pine .750 thick, 5 inches wide, and 38 inches long

    Thanks
    Mark
    Attached Thumbnails Attached Thumbnails DSC_2890.JPG  
    Attached Files Attached Files
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules