is it possible to scan a carving without cutting it out or making a mold of it and then scanning it to get a pattern?
is it possible to scan a carving without cutting it out or making a mold of it and then scanning it to get a pattern?
Hello,
I seem to recall a reading a post or two about folks who have done that with the Scanning Probe. (also see Tips & Tricks - ISSUE 9 June 2008 "Scanning Sled Techniques" page 4)
Last edited by mtylerfl; 05-02-2009 at 07:54 PM.
Michael T
Happy Carving!
╔═══ Links to Patterns & Resources for CompuCarve™ & CarveWright™ ═══╗