here is my 1st competed scan. words of wisdom please
Hess
here is my 1st competed scan. words of wisdom please
Hess
Haven't downloaded and tried to use it, only thing I would suggest is you might set the start & stop a little further out. Then use the editor to eliminate what you don't want. Trying to cut the scan really close often causes a problem with the edges of the object when carved, need to have the depth very close all the way around it.
Great looking , great to see someone interested in what can be reproduced/copied.
Rick H.
Thanks for the input. will do
Hess
Hesstx, I made a PTN from your image, It looks OK, but there is a little roughness. The roughness was because the image loaded in the forum as a JPEG, 12.3kb, JPEG's are noisy.
The other frame you posted looks great. I think the scanning probe is well worth the cost and the software is a lot cheaper than most 3d programs.
Keep up the good work.
Using Designer Version 1.187
Donations are always welcomed, thanks – send a check to my PO Box 652
BJB
PO Box 652
Yellville,AR 72687-0652
PM me for my e-mail address.