Thanks for the reassurance;
I was hoping it wasn’t something I’ve doing wrong on my end.
Thanks for the reassurance;
I was hoping it wasn’t something I’ve doing wrong on my end.
Ken
Ver 1.182 on XL Pro plus Ver 1.164 and 1.175 on Windows 7 Ultimate
It Never Fails * Till * You Say It Never Fails
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
Yep, Thanks Bud,
I was hoping I could access the post and comment form the Forum page
with out switching to the Home Page. Little details like that drive me nuts sometimes,
--- Or maybe I'm just lazy!!
Ken
Ver 1.182 on XL Pro plus Ver 1.164 and 1.175 on Windows 7 Ultimate
It Never Fails * Till * You Say It Never Fails
This is a test.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Evidently the replies have to be made from the HOME page, not this vBulletin article notification thread.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
OK
I've solved the missing "Comment" problem in Windows-7. I'm using IE-8 on this machine.
I found that I had to go to TOOLS > COMPATIBILITY VIEW, and make sure there was no check mark.
Once I did that, the comments appeared!
On my XP machine, I found that I was using IE-7.
I bit the bullet, and upgraded to IE-8 and applied my knowledge from the statement above.
There may be another way to resolve IE-7, but I just opted to upgrade.
AskBud
Last edited by AskBud; 03-31-2011 at 01:13 AM.
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
new question... I just received my new machine and am trying to register it. there are some letters with the number and my brain must be dead but I can't figure how to type a letter on this number pad. PLEASE HELP!!!!!! t
THANKS
DON
Sorry, I found the answer to my question.