I have found a guy that has a probe to sell, but he has no software? Does it need an licence or software, or can i use it with the design software that comes with the machine. Is there a licence to use it with machine?
I have found a guy that has a probe to sell, but he has no software? Does it need an licence or software, or can i use it with the design software that comes with the machine. Is there a licence to use it with machine?
The software for the probe ,last time I checked , was $199.00.
later Daniel
1.187 Custom Woodworking for more than 40-years
So there is seperate software for the probe??? Not the designer software that comes with machine?
thanks
You normally by the probe and software as a set, but yes the software is available seperately for $199.00. The probe does need it's own software.
later Daniel
1.187 Custom Woodworking for more than 40-years
Joe,
The probe software is already embedded in the Designer Software. You will need to activate its license. That's where the $199.00 comes in. You can buy a brand new probe with license for $249.00 at Amazon. Don't pay too much for the used probe.
Bill
Thanks Bill
Thats what I should have said, but being the non-computer savy type person I had to adlib.
later Daniel
1.187 Custom Woodworking for more than 40-years
Plus, didn't I read in here a while back that the probe software license isn't transferable from one owner to another?
If so, I'd be careful about buying a second hand probe. Wherever you get it, new is the best way to go I'd think.
Christopher Neil Albrecht
Occasional Carvings
Just A Flowing With The Grain
Ver. 1.187 on XP Pro Desktop
Ver. 1.187 on Win. 7/64 Laptop
Patterns At The Depot