Question whether the CarveWright can accomplish this:

[Kenm810]

This is a little on the rough side,
but I think it could be done on a Sled

[Dyna Rider]

Hey Ken

Nice work, like the design, what’s the O.D. on the disk?

Bill

[Kenm810]

That ones 4" X 1/4" like one of the disc in the Photo
But you can really carve the ant size you want or Need

[Jeff_Birt]

because of the angle of the carving bit, it is hard to get that detailed.

On 1/4" stock you can use the new 1/16" cutting bit to do the cut-outs. It works very well and very fast.

[Kenm810]

I found 3 different names I posted this photo under, but none have a Ptn or Mpc file listed with them.
I went back through all my back-up files that I have with no luck, I'm wondering now if I didn't save the
files because it was just one of the dozens of test patterns I do for folks.

If per chance someone out there did save the Ptn or Mpc and does have a copy,
could they please post it here for a fellow forum member that has also been looking for it.

Thanks in Advance

[henry1]

I found 3 different names I posed this photo under, but none have a Ptn or Mpc file listed with them.
I went back through all my back-up files that I have with no luck, I wondering now if I didn't save the
files because it was just one of the dozens of test patterns I do for folks.

If per chance someone out there did save the Ptn or Mpc and does have a copy,
could they please post it here for a fellow forum member that has also been looking for it.

Thanks in Advance

Glad to see back, been a while ,I missed you lots hope all is well with you
Henry

[ibanez270]

Thanks for doing this Ken.
I hope your feeling well.
John