Just be careful for the duties and the double check the duties paperwork when the bill comes in. We ordered the rubber belt (99USD+35USD shipping) from LHR and stuck with a $200 duties charge from...
Type: Posts; User: Paul McGrath; Keyword(s):
Just be careful for the duties and the double check the duties paperwork when the bill comes in. We ordered the rubber belt (99USD+35USD shipping) from LHR and stuck with a $200 duties charge from...
41217Fri-07-Jan_01:36:27 PM
Thanks for all the replies and sharing your suggestions. I didn't think of changing the bit size to reduce the feed rate also 4" sounds better than 3.5" on the end....
No sled, the pattern is cut with 3.5" excess material on either end and about 3/16" untouched material on the edges to act as a rail.
I just posted the customer support regarding this, but I thought would ask for advice on the forum as well. We are currently cutting 12mmx36cmx121cm corian and having accuracy problems on a double...
Last night I had some success. I checked the head pressure and it was down at 45 (room temp was 20_C).
Ended up doing the following.
-aligned the vertical posts.
-wd-40 the post and screw to...
Thanks mtylerfl
I checked the O-ring and took off the squaring plate and checked the spring damper. Both looked good.
In the next couple of days I will check the head pressure and double check...
I have a similar problem using the sandpaper belt.
History:
When a longer (36") the board was being measured it threw a "check tracking roller error". Initially I though it was the board lifting...