Search:

I don't remember the exact fault # but it was an Z- asis fault

my machine has 957 cut hours over 1000hr on. I have replaced the brushes 3 times and have a new cut motor on hand

This problem is new to me and I don't remember seeing it on the form. When you load a bit it spins then goes through it's measuring sequence and touches the board tracking encoder assembly(the part...

I change brushes when I reached 250 hr-500hr and the checked at 700 hr althought this was only 200hr the brushes were almost worn out so I think the more hours that you have on the cut motor you need...

The x-y screws are 5mmx14mm x .8thread all in metric
I could not fine allen head screws 14mm long so I used 16mm length they worked fine

:)I have about 1000 hours of cut time and during these times I have had about all the problems out there. With that said I would hate to do with out this machine I use it all most every day. The best...

put me down for one
chipseverywhere:)

Bud
thanks for taking the time to show your techniques it has helped me shorten my learning curve. With out all the help from this forum I would sill be just making scrap pieces.
Thanks again...

here is my 3 cents worth . There is a big difference between chucks. The one that I am using now works great, snap closed and the bit falls out when you want,I have over 100 hr on it. but the one...

I had the same problem so I turned off the machine and unpluged the scaner and then repluged it checking both connections then started to scan and it work correctly hope this is your problem
take...

I have many problems but most were my fault, read the forum and learn and enjoy:p

I just received my machine back from Texas to repair the Z-truck and was told that I had over lubed the flex shaft allowing some to migrate into the cut motor so now they won't warranty my cut...

I have had several adaptors wear out and some have come flying out. When the last one came out it broke the right bottom bearimg off the Z-truck so back to Texas it went. I have be toying with the...

you got my vote it would be a big help

My carver is close to the wall so I ran a 2-1/2" flexhose ( removed the cloth filter and the hose fits over the muffler) out the wall and exhast out side in a bucket with a filter on top, big help...